Kirby Corporation

Medium Voltage Test Technician III

Job Locations US-TX-Houston
Job Post Information* : Posted Date 14 hours ago(11/17/2026 11:32 AM)
ID
2026-4630
# of Openings
1
Category
Manufacturing
Active Company : Name
Stewart & Stevenson Manufacturing Technologies

Overview

Serves as the highest technician level and advanced technical resource, independently performing complex testing and system-level troubleshooting without automatically assuming formal Lead accountability.

Responsibilities

  • Execute complex integrated FATs involving generators, switchgear, load banks, controls, networks, pumps and customer interfaces.
  • Diagnose intermittent and interacting faults using trends, logs, schematics, thermal evidence, network evidence and power measurements.
  • Review interlocks, protective trips, pilot circuits, alarm/shutdown sequences and approved settings with Engineering.
  • Validate technical results against specifications, acceptance criteria, pump curves and stability expectations.
  • Perform advanced use of insulation-resistance, hi-pot/VLF, DAQ, network and power-measurement equipment when separately authorized.
  • Mentor Technician I and II employees and develop troubleshooting guides and lessons learned.
  • Support customer witness testing by explaining technical methods and findings.
  • Provide technical recommendations while escalating staffing, schedule, hold-point and release decisions to the Lead or Manager.

Qualifications

  • Advanced cross-discipline diagnostic and drawing-interpretation capability.
  • Qualified on two or more product families or equivalent approved breadth across major test areas.
  • Demonstrated ability to support more than one test area independently.
  • Current task authorizations for assigned energized or medium-voltage scope.
  • Valid driver license, company-acceptable driving record and limited-travel capability.
  • Suggested experience guideline: 4-10 years of relevant industry experience or demonstrated equivalent advanced competency.

Common Safety, Quality and Documentation Expectations

  • Follow approved procedures, drawings, JSAs, LOTO controls, electrical boundaries, pressure controls and PPE requirements.
  • Stop work for unsafe conditions, unclear instructions, unexpected equipment response, defective test equipment or results outside approved criteria.
  • Verify test instruments are serviceable and within calibration before use.
  • Maintain complete, legible and traceable records, photographs, settings files, reports and discrepancy documentation.
  • Job title does not independently authorize energized work, medium-voltage work, pressure testing, safety-device bypasses or controlled setting changes.

 

Physical Demands and Work Environment

  • Work in manufacturing, shop, indoor-test and outdoor-test environments.
  • Frequent standing, walking, handling, bending and kneeling; occasional climbing and crawling.
  • Frequent lifting up to 20 lb and occasional lifting from 21 to 50 lb, subject to HR/Safety validation.
  • Ability to distinguish indicator/wire colors, read instruments and drawings and wear required PPE.
  • Schedules may change with production and customer-test needs; occasional extended hours or weekends may be required.

Options

Sorry the Share function is not working properly at this moment. Please refresh the page and try again later.
Share on your newsfeed